Engraving machine maintenance guidelines
Engraving machine in normal use should always be clean of impurities,注油lubrication, or engraving machine in the long run under the screw. Rails. Bearings will be quite a number of internal impurities into the dust caused screw. Rotation bearing resistance, will appear Carving slightly faster rate there will be some lost further dislocation phenomenon.

Maintenance of:
1, lubrication of choice: oil and butter mixture, not too crowded.
2, lubricating parts: xyz three-axis screw. Optical bar.
3, lubrication steps: first screw lubrication ago, the mother and guide wire above bearings inside the removal of impurities, if the removal can not, can be used petrol cleansing, after the injection of lubricating oil to gradually increase to high-speed space walk, That is, letting go plate, three-axis run-in.
4, lubrication cycle: As the working environment and machinery to set working hours, usually every day after work, remove ejecta. Each part of fuel per month, high-speed space walk lubrication.
5, lubrication:
Y-axis: lubrication relatively simple, relatively easy to clean-up rails on both sides of Oiling, but can also lead screw from the bottom of the stent into the, it is easier maintenance.
X-axis to be around Xiediao screws, lifted a shield, (Note: the left sides of the line should be brought to relax some of) the right to fully open the oil will be mixed note to the rails, screw, still bearing the right Side screw head of the thrust bearing.
To open the Z-axis shielding, screw, rails, the bearings at the bottom of the thrust bearings will be clear, at this time to do the work: from top to bottom in the operation of lubricating oil mixed note.
In a three-axle lubricant, available within the six-party wrenches and screw on the motor shaft coupling between the head of the six-party screws to tighten against three-axis due to mechanical loosening caused dislocation.

Other maintenance parts:
Pumps. Spindle cutting, the two are mutual, often to replace the water cycle and maintain the water temperature to prevent the net and plug the pump outlet or water-cooled cutting spindle at a high temperature operation caused damage to components.